Control cabinet floor plate, type SBB

The control cabinet floor plate can be installed in Rittal (type CM, TS8 and VX) control cabinets. Up to 5 cable entry systems can be installed.

The scope of delivery of the switch cabinet base plate (type SBB) includes the closure plates type VP 24 or VP/N 24. These are required to lock the floor sheeting into place.

The SBB-VX control cabinet base plate is supplied without closing plates.

Unnecessary cut-outs can be covered with the BP/H 24 blanking plate.

Protection category IP 54 when properly assembled as a system (control cabinet + floor plate)

Can be installed entirely retrospectively

Earthing points (M6 and M8) available on both side

-40°C – 125°C

Galvanised sheet steel Polyamide 6.6

V0

IP 54

Further information

Type Order No. For control cabinet width mm No. Holder slots Cut-out Plate thickness mm A mm B mm Pack qty. Fussnote Variante 2 (unter Var)

and M5 threads

10002x 24-pin TS8 1.54241001 Show Dimensions
6002x 24-pin TS8 1.54641001 Show Dimensions
12003x 24-pin TS8 1.55241001 Show Dimensions
8003x 24-pin TS8 1.56641001 Show Dimensions
10002x 24-pin VX 1.54401001 Without VP, Show Dimensions
6002x 24-pin VX 1.54901001 Without VP, Show Dimensions
12003x 24-pin VX 1.55401001 Without VP, Show Dimensions
8003x 24-pin VX 1.56901001 Without VP, Show Dimensions

with through-hole

10002x 24-pin TS8 1.54241001 Show Dimensions
6002x 24-pin TS8 1.54641001 Show Dimensions
12003x 24-pin TS8 1.55241001 Show Dimensions
8003x 24-pin TS8 1.56641001 Show Dimensions
10005x 24-pin TS8 1.58641001 Show Dimensions
10002x 24-pin VX 1.54401001 Without VP, Show Dimensions
6002x 24-pin VX 1.54901001 Without VP, Show Dimensions
12003x 24-pin VX 1.55401001 Without VP, Show Dimensions
8003x 24-pin VX 1.56901001 Without VP, Show Dimensions

Spare part: Locking plate

5 suitable for KDL/E 24 Show Dimensions
5 suitable for KDP, KDL/C and KDL/D 24 Show Dimensions